TO INSTALL:

Auxiliary Lamp sized applications may best be applied dry.   Wet application is also acceptable.   First, clean lens thoroughly.   Then peel backing off of film (prevent the film from touching any foreign surfaces).  

Wet application: Very light mist of water onto lens (1 spray only), outside of film and your fingers.   Then align and apply film to one side or center of the lamp or area to be protected.   Using a plastic application card or towel wrapped credit card, press down /sweep the remainder of the film across the lamp.   Film is very forgiving.   You can remove and reinstall numerous times until satisfied and perfect.   If film is not pre-cut, then use an X-acto knife, trianular pointed knife or razor blade to trim off the excess film.   If the product is pre-cut, then remove the handling tabs.

SETTLING:

Small air bubbles, cloudiness and surface texture/scratches will disappear over time as the fims settles and is warmed.   Allow a few days to a couple of weeks for the process to complete.   Performing the suggested maintenance care may help assist the process.  

MAINTENANCE:

The film can be washed with soap and water just as you would use on your cars finish.   Light scrubbing is ok well as mild solvent if needed.  

It is important to wax the film quarterly with a good quality Carnauba wax or vinyl conditioner to maintain the film's UV (Ultra Violet) protection.